![background image](http://html1.mh-extra.com/html/club-car/carryall-1/carryall-1_maintenance-and-service-manual-supplement_2626702076.webp)
IQ DISPLAY MODULE (IQDM) SERIES 2 AND IQDM-P DIAGNOSTICS
Test Procedures
Page 12-18
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
12
TEST PROCEDURE 2 – HANDSET CORD ADAPTOR
See General Warning, Section 10, Page 10-1.
The procedure for testing the handset cord adaptor is similar to the cord test.
1. Using a multimeter set for 200 ohms, place the red (+) probe into one of the terminals on the end of the
adapter with the square plug.
2. Place the black (–) probe on each of the pins, one at a time, on the other plug of the adaptor.
3. The multimeter should indicate continuity on only one pin. If any other reading is obtained, the adaptor
must be replaced.
4. Repeat the procedure three more times, each time with the red (+) probe inserted into a different terminal
on the end of the adaptor with the square plug.
TEST PROCEDURE 3 – IQDM JACKS
See General Warning, Section 10, Page 10-1.
Test Procedure 3A – IQDM Jack (Located Under Seat) (DS Villager 4)
1. Lift and remove seat and locate IQDM jack under seat
.
2. Remove rubber environmential cover and visually inspect the contacts for damage and corrosion.
Inspect the IQDM jack and repair and replace parts as necessary.
Test Procedure 3B – IQDM Jack (Located Under Instrument Panel) (Turf 1/Carryall 1)
See General Warning, Section 10, Page 10-1.
1. Turn the key switch to the OFF position, place the Forward/Reverse switch in the NEUTRAL position,
and lock the park brake.
2. Place the Tow/Run switch in the TOW position, disconnect the batteries, negative (–) cable first, and wait
90 seconds for the speed controller capacitors to discharge.
See General Warning, Section 10,
Figure 12-8 IQDM Jack Under Seat in Stowed Position
(DS Villager 4)