![background image](http://html1.mh-extra.com/html/club-car/carryall-1/carryall-1_maintenance-and-service-manual-supplement_2626702156.webp)
TRANSAXLE (TYPE G)
Transaxle
Page 17-6
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
17
5. Disconnect the shock absorbers from their lower mounts
6. Disconnect the four motor wires. Use two wrenches to prevent the post from turning.
7. With a floor jack supporting the transaxle, remove lower spring shackle nuts and bolts. Position shackles
8. If a chain hoist was used to raise the vehicle, lift the vehicle high enough to permit easy access and clear-
ance for removal of the motor. If a floor jack was used to raise the vehicle, lower the transaxle enough
to permit easy access and clearance for removal of the motor.
9. Remove the three motor mounting bolts
and the motor positioning bolt
mounting the motor to the transaxle.
See following CAUTION.
ý
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
10. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor
spline becomes disengaged from the input shaft, then lift motor out.
See preceding WARNING.
11. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the
floor.
12. Remove the U-bolts attaching the transaxle to the leaf springs
13. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle
to the rear and out of the vehicle.
14. Drain the lubricant from the transaxle and remove the axle shafts.
See Axle Shaft and Oil Seal Removal
See following NOTE.
NOTE:
15. Remove the brake assemblies if required.
See Section 6 – Wheel Brake Assemblies in the appropri-
ate maintenance and service manual.
Figure 17-10 Leaf Springs
Figure 17-11 Motor Mounting Bolts
DIFFERENTIAL
GEAR CASE
MOTOR MOUNTING
BOLTS
INTERMEDIATE
GEAR ASSEMBLY
INPUT
PINION
GEAR