Club Car Carryall 1, Maintenance And Service Manual Supplement, Page: 77 / 176

IQ DISPLAY MODULE (IQDM) SERIES 2 AND IQDM-P DIAGNOSTICS Test Procedures
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement Page 12-19
12
3. Check the IQDM jack mounted under the instrument panel.
3.1. Remove the center dash panel (Figure 12-9, Page 12-19) .
3.1.1. Remove the plastic cap (1) covering the mounting screw (2) on each side of the center
dash panel (3) (Figure 12-9, Page 12-19) .
3.1.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
3.1.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry
center dash out slightly from under edge of cowl brace.
3.1.4. Pull center dash out from the frame carefully and expose the wiring of the electrical com-
ponents mounted on the dash panel. Do not allow wires to touch. See following NOTE.
NOTE: Take care to prevent key switch terminals and wires from touching the metal frame around the
dash.
3.2. Disconnect the IQDM jack four-pin connectors (4 and 5) and visually inspect the contacts for dam-
age and corrosion. Inspect the IQDM jack mounted to the bottom of the dash panel. Repair and
replace parts as necessary.
3.3. If no problem is found, connect the multi-pin connectors and install the center dash panel.
3.4. Install the three self-tapping screws that hold the F&R rocker switch case (2) to the body. Tighten
to 20 in-lb (2.2 N·m).
3.5. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack. If the hand-
set fails to function, See IQDM and IQDM-P Handset Troubleshooting on page 12-15.
Test Procedure 3C – IQDM Jack (Speed Controller)
4. Check the IQDM jack on the speed controller.
4.1. Remove the two screws securing the rear body access panel and remove the access panel.
4.2. Remove the two screws (5) securing the controller cover (1) to the component mounting plate
(Figure 12-10, Page 12-20) .
4.3. Disconnect the square four-pin connector (3) from the speed controller.
4.4. Connect the handset cord to the handset.
4.5. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of the
speed controller (2) (Figure 12-10, Page 12-20) .
4.6. Connect the batteries. See Connecting The Batteries on page 10-3.
Figure 12-9 Testing IQDM Jack - Turf 1/Carryall 1
4
5
3
1
2