Club Car Carryall 1, Maintenance And Service Manual Supplement, Page: 86 / 176

ELECTRICAL COMPONENTS Solenoid
Page 13-8 2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
13
4.2. Lift the solenoid (3) up and off of the component mounting plate.
5. Slot-mounted solenoid (Figure 13-8, Page 13-8) .
5.1. Slide solenoid up to disengage the mounting tabs and remove from component mounting plate..
Solenoid Installation
1. Mount solenoid onto component mounting plate with screws (12) or by engaging slot (Figure 13-7,
Page 13-8) (Figure 13-8, Page 13-8) .
2. Tighten screws (12) to 60 in-lb (6.8 N·m).
3. Using the wiring diagram, install the wires, resistor (9), washers (8), and nuts (7) onto the large mounting
posts. Tighten nuts to 77 in-lb (8.7 N·m). See Wiring Diagrams, Section 11, Page 11-2.
4. Install the blue/white and light blue wires onto the small terminals of the solenoid (Figure 13-7,
Page 13-8) .
5. Install rear body access panel.
6. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
Figure 13-7 Screw-Mounted Solenoid Figure 13-8 Slot-Mounted Solenoid
9
3
7
8
12