TH82 Series Reference Manual
6/6
1.4 ATTACHING THE DRAWER, GROUND WIRE AND POWER SUPPLY
DRAWER KICK CABLE
DC CABLE GROUND WIRE
1.4.1 THE
DRAWER
CAUTION :
You need a drawer that fits the printer’s specification.
Do not connect a telephone line to the drawer kick-out connector.
Plug the drawer kick cable into the kick-out connector. If two drawers are used, use a Y-cable that
meets the specifications on page 14 to ensure that both drawers receive signals correctly.
1.4.2 GROUND
WIRE
Use a ground wire that matches your printer. It is recommended to use a ground wire that is at least
the same length as the power cable. Connect the ground wire to the back of the printer with the
supplied screw as shown above.
1.4.3 POWER
SUPPLY
CAUTION :
Before connecting or disconnecting the power supply to the printer, make sure that the power supply is unplugged from the
power outlet and connect the power cord into the adapter.
1: Make sure that the adapter plug is unplugged from the power outlet.
2: Plug the DC cable into power connector with the flat side of the plug turned up.
CAUTION :
When disconnecting the adapter, turn the printer off and the DC cable out by gripping the
plug. Do not pull it out by the cord.
1.5 SELF TEST
Use the self test to check that your printer is operating properly. It checks the control circuits, printer
mechanisms, print quality, and displays the firmware version and DIP switch settings.
1 : Make sure that the printer cover is closed properly and turn the power off.
2 : While holding down the FEED button, turn the printer on and continue holding down the FEED
button until the self test starts.
3 : The self test will end automatically and detach the self test print out.
NOTE :
Refer to
CHAPTER 3, MAINTENANCE & TROUBLESHOOTING
about how to install and
replace
the paper roll
.
