Clover TH82, Reference Manual

Page: 56 / 68

TH82 Series Reference Manual
56/56
GS P Specify basic calculate pitch
[FORMAT]
<1D>H<50>H<x><y>
[RANGE]
0 ≦ x ≦ 255
0 ≦ y ≦ 255
[FUNCTION]
*Specifies the horizontal and vertical motion units to approximately 25.4/xmm{(1/x) inches} and
approximately 25.4/ymm{(1/y) inches}.
*When x = 0, the default setting of horizontal motion unit is used.
*When y = 0, the default setting of vertical motion unit is used.
[DETAILES]
*The horizontal direction is the perpendicular direction to the paper and the vertical direction is the
paper feed direction.
*The following commands are used, regardless of the character rotation (upside-down or 90
°
clockwise rotation), in standard mode.
① Commands using
x
:
ESC SP, ESC $, ESC
╲
, FS S, GS L, GS W
②
Commands using
y
:
ESC 3, ESC J, GS V
*The following commands are used depending on the character orientation in page mode.
① When the print starting position is specified to the upper left or lower right by
ESC T
(data is buffered in the perpendicular direction to the paper feed direction.)
*Commands using
x
:
ESC SP, ESC $, ESC W, ESC
╲ ,
FS S
*Commands using
y
:
ESC 3, ESC J, ESC W, GS $, GS
╲
, GS V
② When the print starting position is specified to the upper right and the lower left by
ESC T
. (data is buffered in the paper feed direction.)
*Commands using
x
:
ESC 3, ESC J, ESC W, GS $, GS
╲
*Commands using
y
:
ESC SP, ESC $, ESC W, ESC
╲
, FS S, GS V
*This command does not affect the previously setting values.
*The calculated result from combination width other commands is truncated to the minimum value
of the mechanical pitch.
[DEFAULT]
x=180 、 y=360
GS V Cut paper
[FORMAT]
<1D>H<56>H<m>
<1D>H<56>H<m><n>
[RANGE] ①
0 ≦ m ≦ 3, 48 ≦ m ≦ 51
②
65 ≦ m ≦ 68, 0 ≦ n ≦ 255
[FUNCTION]
Executes cutting paper specified as follows.
[CAUTION]
*This command is effective only when processed at the beginning of a line.
* Paper must be fed 3 mm after printing to prevent paper jam.
m Function
① Full cut (one point left uncut)
②
Feeds paper (cutting position
＋
n
× vertical motion unit) and cuts the paper
fully (one point left uncut).