CLIVET CSRN-XHE2 Series, Manual

Page: 66 / 92

66
Ionisation wires
The impurities can determine oxidation or scaling on the wires,
which can be removed using a cloth soaked in alcohol or an
abrasive scourer with very fine grain.
Due to the high voltage powering them, the ionisation wires are
subject to wear.
To foresee a yearly replacement OF ALL WIRES avoids unexpected
breaks.
In case of break:
1 remove all wire pieces present in the cell and remove the
springs stretching the wire;
2 hook the spring to the wire eyelet;
3 grip the ionisation wire with curved beaks pliers;
4 hook the top of the spring with the open eyelet to the wire
stretcher rod of the electrostatic cell;
5 keeping the ionisation wire stretched, with the other hand hook
it to the other wire stretching rod, always by means of the
curved beaks pliers.
Immerged electrodes humidifier
Option
Do not use solvents or detergents to clean the plastic
components.
For descaling use a vinegar or acetic acid solution at 20%,
subsequently rinsing with water
15
days
Cylinder:
not over 300 hours of work
checking operation, general state, no leaks
90 days
Cylinder:
not over 1000 hours of work
checking operation, general state, no leaks, any replacement
1 year
Cylinder:
not over 2500 hours of work (disposable cylinders)
Load solenoid valve replacement: disconnect electric power
supply, dismantle valve, clean the drain solenoid valve filter:
disconnect electric power supply, remove reel and dismantle valve
body and any impurity and rinse the power supply bowl, piping:
check they are free and without impurities
5 years
Cylinder:
not over 10000 hours of work (inspectional cylinders)
replacement
Periodical checks