CLIVET CSRN-XHE2 Series, Manual

Page: 64 / 92

64
Condensation collection basin
Dirt or scale can give rise to clogging.
Also, microorganisms and mould can flourish in the bowl. It is
very important to foresee periodical cleaning with suitable
detergents and, eventually, disinfect with sanitising products.
Once cleaning is completed, pour water inside the bowl to check
the regular outflow.
Compressor supply line shut-off valve (A)
Only if present
Do not remove the seal
Remove only if authorized by the manufacturer.
Please contact the maker for informations.
Compressor crankcase heaters
Check :

closing
 operation
G4 Folded air filters
It is very important for the air treatment coil to offer maximum
thermal exchange: the unit must always work with clean and
installed filters. Cleaning and replacement of filters are very
important from an hygienic-sanitary point of view.
Operation with clogged filters leads to a reduction in the air flow
rate with malfunctionings and block, up to possible breaks in the
unit.
The frequency with which the filters must be checked depends on
the quality of the outdoor air, the unit operation hours, the
dustiness and crowding of rooms.
Frequency can indicatively vary from WEEKLY to MONTHLY. It is
advised to start with frequent checks, subsequently adjusting
frequency to degree of detected dirt.
1 Remove the closing panels
2 Delicately remove the filter avoiding dirtying the area below
3 Wash the filtering jacket in warm water with common
detergent
4 Accurately rinse in running water avoiding spilling in the room
5 Dry the filter
6 Insert it back in its seat
7 Remount the closing panels
Old filters, washing wastewater and residues must be disposed of
according to the current standards.