23
CM7015
6. CM7 Temperature & Humidity Sensor
Configuring Channels
The Channel ID of each sensor can be changed at any time using the Channel Selector
found underneath the battery cover. When setting or changing the Channel ID of a
sensor, please note you’ll also need to remove and re-insert the sensor batteries in order
for this change to take effect. Any time a Channel ID setting is changed, you will also
need to carry out the Sensor Search Mode on your Display Console (found on Page 17 of
this handbook) to prompt all connections to be refreshed. Each sensor can use a numeric
channel from 1 to 8, but if a particular channel is being used by multiple sensors only one
of these will be picked up on the console, so be sure to select unique Channel ID’s for
each of your sensors.
To change the channel of a sensor, locate the Channel Selector by removing the battery
cover from the rear of the relevant CM7. The Channel Selector is made up of four DIP-
switches and will appear as follows:
