MEDIPULSE 2342se ERGONOMIC SUCTION BLAST CABINET
Page 19
© 2019
CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 24939, Rev. C, 03/19
7.4
View-Window Replacement
WARNING
Do not use plate glass for replacement view
windows. Plate glass shatters on impact and
can cause severe injury. Use only genuine
ZERO
®
laminated replacement glass.
7.4.1
Remove the two window-frame nuts located on
the upper edge of the window frame and swing the
window frame open. If the frame is to remain open for
cleaning or other reasons, remove it, per Section 7.6.
7.4.2
Remove the old window.
7.4.3
Inspect the window-frame gaskets on both the
window frame and on the cabinet. If either gasket is
damaged, replace it, per section 7.5.
7.4.4
Install a view-window cover lens, per Section 7.3.
7.4.5
Set the new window (cover lens down) squarely
over the window opening, making sure that all edges of
the window are centered and overlapping the window
gasket, and that the window is resting on the window
support tabs.
7.4.6
Swing the window frame into place and tighten
the frame nuts.
7.5
Window-Gasket Replacement ‒ Figure 25
7.5.1
Inspect the gaskets when changing the view
window. Replace the window-frame gasket and cabinet
window-opening gasket at the first sign of media leakage
around the view window, or if gaskets are worn or
otherwise damaged.
Figure 25
7.5.2
Remove the window and window frame, per
Section 7.6.
7.5.3
Remove all the old gasket material and clean
the surfaces of the cabinet and window frame.
7.5.4
Peel a short section of adhesive backing from
the 5/16
-thick strip gasket and adhere the gasket to the
center of the top edge of the window opening, as shown
in Figure 25. Peel additional backing as needed and
work the strip around the radius of each corner, pressing
it firmly to bond. Trim the gasket to fit and compress the
ends to seal.
7.5.5
Using 5/32
-thick strip gasket, repeat the
process on the underside of the window frame.
7.5.6
Trim around the window-frame bolt slots, as
needed.
7.6
Window-Frame Removal ‒ Figure 26
7.6.1
Remove the two window-frame nuts located on
the upper edge of the window frame and swing the
window frame open.
7.6.2
Remove the window to prevent breakage.
7.6.3
Pivot the window frame up or down until tension
is off the frame hinges.
7.6.4
Slide the frame to the right to remove it. The
hinges separate, as shown in Figure 26.
Figure 26
7.6.5
Replace the frame in reverse order. Slide the
frame as necessary to align the top bolt holes with the
bolts.
Cabinet Front
Window Frame
5/16
x 3/4
Gasket
5/32
x 3/4
Gasket
Support Tabs
Pivot the frame up or down
until tension is removed
from the hinges.
Support Tabs
Slide the frame to the right
to separate the hinges.