MAINTENANCE
40
Tennant T300 (03- 2015)
2. After charging batteries, check the battery
electrolyte level indicators located on the battery
covers (Figure 119). If the level indicator is white
add water as described in the following
instructions. If the level indicators are black the
electrolyte is at the correct level, no water is
required.
FIG. 119
3. Locate the battery fill hose coupler inside the
battery compartment. Remove the dust cap and
connect the hand pump hose (Figure 120).
FIG. 120
4. Submerge the other end of the hand pump hose
into a bottle of distilled water (Figure 121).
Distilled
Water
FIG. 121
5. Squeeze the bulb on the hand pump hose until firm
(Figure 122). The level indicators will turn black
when full.
FIG. 122
6. After adding water, replace the dust cap on the
battery fill hose and store the hand pump hose
inside the machine’s battery compartment for future
use.
SQUEEGEE BLADE REPLACEMENT
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, remove key
and set parking brake if equipped.
Each squeegee blade has four wiping edges. When the
blades become worn, simply rotate the blades
end-for-end or top-to-bottom for a new wiping edge.
Replace blade if all four edges are worn.
1. Remove the squeegee assembly from the machine.
2. Fully loosen the two outside knobs on squeegee
assembly. This will separate the spring loaded
blade retainer from squeegee frame (Figure 123).
To loosen the knobs quickly, squeeze the blade
retainer and squeegee frame together.
FIG. 123
