OPERATION
18
Tennant T300 (02- 2017)
T300 WITH PRO-MEMBRANE CONTROL PANEL
(Actuated Down Pressure Model)
The control panel operation can be set up with lockout
functionality by using the supervisor controls feature.
This will prevent an operator from changing or saving
the Zone Settings. See SUPERVISOR CONTROLS
instructions at back of manual.
1. Turn the key to on ( I ) position to power up
machine.
Models equipped with the ec-H2O option - The
ecH2O system will automatically turn on at start up.
A blue ec-H2O icon will appear on the control panel
(Figure 37). This indicates that the ecH2O system
is turned on and ready for operation. To turn off the
ec-H2O system, press the ec-H2O switch located
below the key switch.
FIG. 37
2. Press the down pressure button to increase or
decrease the down pressure (Figure 38). The down
pressure indicator will display the pressure setting.
One LED = Low pressure, two LED’s = Medium
pressure, three LED’s = High pressure.
FIG. 38
3. Press the solution flow button to increase or
decrease the solution flow rate (Figure 39). The
solution flow indicator will display flow setting.
No LED = No flow, One LED = Low flow, two
LED’s = Medium flow, three LED’s = High flow.
FIG. 39
4. Models equipped with Severe Environment button
option - Press Severe Environment button one
time to dispense cleaning detergent for 30 seconds
(Figure 40). A green LED in the corner will blink
slowly when dispensing. During the last 5 seconds,
the LED will blink rapidly as an alert that the
dispensing is about to stop. For continuous
dispense, press and hold the button for 2 seconds
until LED turns solid green. Press button at
anytime to turn off.
The icon will blink blue when the severe
environment tank needs to be refilled.
NOTE: When the severe environment mode is
turned on, the down pressure and solution flow
settings automatically increase to the high setting.
When turned off, the settings revert back to the
original settings. When operating the Severe
Environment mode for extended periods, if desired,
the solution flow rate and the down pressure can
be decreased to a lower setting to conserve
solution and detergent usage and optimize battery
run time.
FIG. 40
5. Press the Quiet-Mode button to reduce the vacuum
motor sound (Figure 41). A green LED in the
corner will turn on when mode is activated. Press
button to turn off.
NOTE: Water pickup will reduce slightly when
Quiet-Mode is activated.
FIG. 41
