OPERATION
Tennant T300 (02- 2017)
21
NOTE: When the severe environment mode is
turned on, the down pressure and solution flow
settings automatically increase to the high setting.
When turned off, the settings revert back to the
original settings. When operating the Severe
Environment mode for extended periods, if desired,
the solution flow rate and the down pressure can
be decreased to a lower setting to conserve
solution and detergent usage and optimize battery
run time.
7.
Press the quiet mode icon to reduce the
vacuum motor sound for noise restricted areas
(Figure 52). The icon will turn green when
activated. Press again to turn off.
NOTE: When the Quiet-Mode is activated the
water pickup will slightly be reduced.
FIG. 52
8. Press the Zone Setting numbers for quick
operation (Figure 53). The zone number will turn
green when activated. Each Zone Setting number
is factory configured with different solution flow
rates, down pressures and maximum scrub
speeds.
FIG. 53
To change the default zone settings - Configure
the desired zone settings then press and hold the
zone number button until it prompts you to name
the new zone setting. Select “yes” to enter a new
name (Figure 54). By selecting “no”, the preset
name will be removed.
NOTE: Only the supervisor mode has the capability
to change the factory zone settings (See
SUPERVISOR CONTROLS instructions at back of
manual).
The zone settings can configure the following
controls:
- Down pressure rate
- Solution flow rate
- Quiet-Mode on or off (option)
- Maximum scrub speed (drive model)
- ec-H2O mode on or off (option)
- Severe Environment mode on or off (option).
NOTE: The Severe Environment and ec-H2O
modes cannot be configured together.
FIG. 54
If the zone settings are configured to scrub a lobby
for example, rename the zone “LOBBY” (Figure
55). Press the green arrow to set new zone setting.
FIG. 55
The name will appear above the zone setting
number when the zone button is pressed (Figure
56). Repeat process for other zone settings.
FIG. 56
