91c_LCD en bedingt.fm, 24.09.2007
P1891E/EN 09/07
23
LCD display
6
Additional messages in "Linking" mode
Error in last data synchronization with the TMEB-200 / TMEB-COM / TMEC.
➔
Synchronize the tool with the TMEB-200 / TMEB-COM / TMEC again.
Tool has not yet been synchronized with a TMEB-200 / TMEB-COM / TMEC.
➔
Carry out initial synchronization of the tool with the TMEB-200 /
TMEB-COM / TMEC.
The
Tool Enable
input is missing.
➔
Set the
Tool Enable
input.
➔
Synchronize the tool with the TMEB-200 / TMEB-COM / TMEC.
This message can appear only if
External Tool Enable
has been activated
in
Advanced Application Builder\System settings
.
Tool disabled since no valid barcode data has been set.
➔
Send the barcode to the TMEB-200 / TMEB-COM / TMEC.
➔
Synchronize the tool with the TMEB-200 / TMEB-COM / TMEC once
again.
First line: The next position to be fastened.
Second line: Number of positions.
Third line: Number of repetitions at this position in case of an NOK rundown.
Linking has been cancelled without a batch result.
Not all of the positions in the tightening group have been programmed.
➔
Check the Application and Tightening group selected on the TMEB-200 /
TMEB-COM / TMEC to determine whether the tool settings and process
programming have been carried out.
Linking result OK.
Linking result NOK.
Sync
Error
Tool
not
Init
Input
Enable
Missin
Need
Part
ID
N.Pos1
of 3
Rpl 0
Linkin
No
Result
Linkin
OK
Linkin
NOK
