32
P1891E/EN 09/07
91c_LCD en bedingt.fm, 24.09.2007
LCD display
6
6.4
System error messages
Displays the tool ID and allows you to configure settings.
You can select a tool ID from 1 – 4.
➔
<F1>: Activate a lower network ID.
➔
<F2>: Activate a higher network ID.
➔
Press the start button or <F2> longer than 2 seconds
to accept the select and display the next menu item.
➔
Press <F1> longer than 2 seconds
to delete the selection and exit the menu.
NOTE
Each tool can be used only once for each base station.
Displays the transmission power and allows you to configure settings.
➔
<F1>: Activate a lower transmission power.
➔
<F2>: Activate a higher transmission power.
➔
Press the start button or <F2> longer than 2 seconds
to accept the select and display the next menu item.
➔
Press <F1> longer than 2 seconds
to delete the selection and exit the menu.
For 868 MHz, the maximum transmission power depends on the selected chan-
nel. If channel 1 is selected, you can choose between 1, 5, 10, and 25 mW for
the transmission power. If channel 2 or 3 is selected, you can choose either 1 or
5 mW for the transmission power. For 915 MHz, you can choose between 1, 5,
10, and 25 mW.
➔
Press the start button or <F2> longer than 2 seconds
to accept the select and display the next menu item.
➔
Press <F1> longer than 2 seconds
to delete the selection and exit the menu.
NOTE
If a error is displayed, fastening is disabled until the error is acknowledged with the left-hand but-
ton on the tool. In the event of serious hardware errors, the tool is not enabled again even after
the error is acknowledged, and must be returned to the manufacturer for repair.
Initialization error in tool servo.
➔
Remove the battery and then re-insert it. If this does not help:
➔
Return tool to manufacturer for repair.
Tool
ID
1/4
Power
25 mW
Servo
Error
Init
