23
Revision date: 02.07.12
CLEARSPAN
™
POLY BUILDINGS
8. Move to the end of the frame opposite the end where
the temporary straps were tied to keep the main cover
centered on the frame.
9. Take one end of the bulk roll of 2" strapping and weave
it around the end rafter and PVC conduit.
Weave the
strap around the top or outer tube of the end rafter.
INSTALL PVC CONDUIT (CONTINUED)
Photo shows how to
weave strap around
the conduit inside the
main cover pocket.
Cover shown differs
from actual cover.
10. Continue to weave the strap around the end rafter and
PVC conduit working up and over the rafter and down
to the other end of the PVC conduit.
NOTE:
Keep the strapping snug during this step, but
do not over tighten. Also, maintain a even distance
between the top of the end rafter and the PVC conduit.
Photo shows the installed strapping. Distance between the
conduit in the pocket and the end rafter is even.
11. After weaving the strapping, cut the strap and tie it to
the end rafter to temporarily secure it.
12. Take the remainder of the bulk strap roll, move to the
other end of the frame and repeat the steps to weave
the strap between the PVC conduit and the top of the
end rafter.
NOTE:
The temporary straps at this end (Step 7) can
be removed once the main strapping is in place.
13. After the strap is completely installed at this end, cut
the strap to length and tie it to the end rafter.
14. With the strap tied to the end rafter, tighten the strap.
This strapping will pull against the strapping installed at
the other end of the frame.
NOTE:
Maintain an even distance between the end
rafter and the PVC conduit as the strap is installed and
tightened.
Also check that the bonnet portion of the main cover
overlaps the end rafters evenly before stretching the
cover.
If the side straps are too tight to stretch the cover from
end-to-end, loosen the straps as needed and continue.
15. Once the strap is tight, cut it to length if needed and tie
it to the other leg of the same end rafter.
16. Return to the other end of the frame and tighten that
strapping if needed to complete the stretching of the
main cover from end-to-end.
17. With the cover properly stretched, continue by
tightening the side ratchets.
Summary of Contents for 106786
