5
CLEARSPAN
™
CEDAR GREENHOUSES
Revision date: 06.16.09
Ground Level
1
FRONT
BACK
SIDE
SIDE
1
SIDE BOARD
BACK BOARD
ATTENTION:
Verify that the
front and back boards
are seated
against the corner bracket.
2
3
Outside
Inside
Align the
centers of the
connectors with
the measured
marks.
ASSEMBLE BASE FRAME
Consult the
Assembled Base
and
Exploded Base Views
at the back of these instructions to assemble the
base frame.
NOTE:
All screws in this step are installed in the sides of the baseboards. DO NOT install screws into the
top of the baseboards.
Gather the correct board lengths and assemble each baseboard using two (2) middle connectors; one
1.
placed over the top edge and one placed over the bottom edge at the joint between the boards. Use
3/4" Phillips head screws (FAF25P) to secure middle connectors.
With the baseboards assembled, attach the corner brackets as shown below using 3/4" Phillips head
2.
screws (FAF25P) to secure. Repeat at the remaining corners. Consult diagrams to properly install the
corner brackets and to assemble the frame.
On each
3.
side
, attach pass-thru connectors (#104639) in the locations shown below. Consult the
Assembled Base View diagrams near the back of these instructions for the correct measurements and
locations. Use 3/4" Phillips head screws (FAF25P) to secure pass-thru connectors.
Consult the diagrams near the back of these instructions
4.
to square and anchor the assembled frame
.
