11
CLEARSPAN
™
CEDAR GREENHOUSES
Revision date: 06.16.09
NOTE:
If needed, remove
rafter bracket, adjust to fit
the rafter assemblies, and
reattach.
3
Secure using
FAF25P Phillips
head screws.
4
Secure using
FAF25P Phillips
head screws.
Frame length of your building may differ
from what is shown.
7
CG12135
CG12137
104643
FAF25P
1
CG12135
CG12137
10513612
NOTE:
Verify ridge
assembly is connected
as shown or the rafter
brackets will not align with
the rafters. Consult
Ridge
Assembly
page near the
back of this manual.
ASSEMBLE AND INSTALL RIDGE ASSEMBLY
IMPORTANT:
Consult the
Ridge Assembly
diagram in
the back of these instructions to properly connect the
ridge assembly.
Ridge sections are shipped with brackets and
connectors already attached. If the sections are not
connected, assemble the ridge sections as shown,
attach assembled ridge beam to frame, then attach the
4-way connectors using the rafters as guides.
Assemble the ridge beam using a middle
1.
connector placed over the bottom edge at the joint
between the boards. Use 3/4" Phillips head screws
(FAF25P) to secure middle connector.
ATTENTION:
When assembled, verify that the
on-center distance between each rafter bracket is
25-1/2".
With the ridge beam assembled, position it
2.
between the peaks of the end walls and align the
rafter brackets with the middle rafter assemblies.
Once the ridge assembly is aligned with the middle
3.
rafters, seat the assembly into the ridge brackets
attached to the end rafter assemblies. Secure
using 3/4" Phillips head screws (FAF25P).
Secure each rafter bracket to the rafter assemblies
4.
using 3/4" Phillips head screws (FAF25P).
