54
Technical Support: 800-283-5936
s
eT
u
p
ip f
ilTering
Enter specific IP addresses that will be allowed to access the INTERACT system.
IP filters allow you to restrict access to your INTERACT system. Only computers with the specified IP address
can connect to INTERACT.
A range of IP Addresses can be specified by using zeros. For example, entering 192.168.105.0 will allow any
IP addresses in the 192.168.105.1 to 192.168.105.254 range to access the INTERACT system.
u
ser
/p
assword
To change or set a user name and password please do the following:
6. Click the
User/Password
button
7. Enter a new user name in the
User Name
field
8. Enter a new password in the
Password
field
9. Enter the password again in the
Confirmation
field
10. Click
Ok
to set the new user name and password or
Cancel
to discard the information
Serial Tab
The
Serial Tab
allows you to adjust settings for the Control Port.
•
Baud Rate
: Adjusts the data rate for the port - default is 57600 baud.
•
Flow Control
: This setting manages the data rate between two data nodes, preventing a fast sender
from “outrunning” a slow receiver. The default for this setting is “On”.
Radio Settings - INTERACT Pro and AT
The
Radio Settings
tab allows the user to customize wireless settings for INTERACT components.
•
Click
Radio Enable
to activate/deactivate the wireless radio used by the INTERACT hardware.
•
Radio Frequency
is selected by clicking on and selecting a frequency from the
Radio Frequency
drop
box.
•
Assign a unique ID to your INTERACT device.
C
lear
C
hannel
a
ssessMenT
•
ClearChannel Assessment
scans the radio channel frequency chosen for your INTERACT device and
reports whether there is traffic on that frequency. Click
Run
to start this process.
e
nable
r
adio
s
TaTisTiCs
•
Click the
Enable Radio Statistics
check box to display
Link Quality
,
RSSI Level
and
Packet Error
statistics for the device.
•
Click
Ok
to save your changes.