26
Technical Support: 800-283-5936
INTERACT AT - AUDIO CONFERENCING SETUP
1. If you are installing the mixer into a rack, remove the side panels, rotate them and then reattach.
2. Connect the first Microphone Breakout Box to the mixer with the included CAT5 cable.
3. Connect the second and third Breakout Boxes using CAT5 cables (A total of 3 Microphone and 1 COM
Breakout Boxes can be connected).
4. Connect the Microphones to the Breakout Boxes, as needed.
5. Connect the speakers to the mixer.
6. Using the RJ-11 cable, connect an analog telephone jack to the
Line
jack on the mixer.
7. Using an RJ-11 cable (not supplied), connect an analog telephone set to the
Set
jack on the mixer
(optional)
8. Using the CAT5 cable, connect the mixer to the network. (Network settings can be changed in
INTERACT software.)
9. Connect the power supply to the INTERACT AT.
10. If using the wired controller, connect the controller to the mixer’s RS-232 serial port using the supplied
RJ-11 to DB-9 adapter. If using the RF controller, attach the external antenna and turn it until it is upright.
11. If using the RF controller, insert four AAA batteries into the battery compartment in the bottom of the
Dialer-W unit.
AUXILIARY DEVICES (INTERACT AT)
The mixer allows connection to a number of different audio and video peripherals, such as video codecs,
VCRs, DVD players, cameras and computers.
Connecting Video Codecs and Amplifiers
Line Input/Output devices such as video codecs, amplifiers and sound cards can be connected to the Line
In or Line Out connectors on the INTERACT mixer. These connectors provide mono-audio.
Connecting a Video Codec
1. Using an RCA cable, connect the
Line In
on the INTERACT mixer to the line out on a video codec.
2. Using an RCA cable, connect the
Line Out
on the INTERACT mixer to the line in on a video codec.
Connecting an External Amplifier
Using an RCA cable, connect the
Line Out
or
Record Out
on the INTERACT mixer to the Line In on an
amplifier.
»
NOTE
: Use the INTERACT software to adjust the equalization and volume of these devices.
Refer to pages 26-31 for more information. When using the INTERACT software, be sure to
drag the amplifier to the correct device (either Line Out or Record). This will properly assign
the AEC reference and change the volume command on the controller to control the external
amplifier volume.
»
NOTE
: The INTERACT COM allows direct interface to a PC from the USB for the audio
connection.