17
Four Gel batteries type Dryfit each 6 V / 180 Ah provide the Ride-on-Sweeper KS1100 with power. The
charging status of the batteries can be read on the battery indication on the Operator Panel.
Signification of the LED lights on the battery status panel
When switching ON the Ride-on-Sweeper immediatley the LEDs start blinking, nicely one
after another, beginning at the minus/negative terminal and blinks along to the plus/
positive terminal. The result of this self-test is indicated by the 10 LED‘s..
1 LED
= Working status / charging status is critical...until….
10 LED‘s = Work status / charge status is not critical, charging completed
Charging the batteries
• Switch-OFF the Ride-on-Sweeper
• In view of driving direction, on the right
hand side, Above the rear wheel is the
socket connection for battery charging
• Open the cover and connect the plug of
the charger to the battery socket on the
Ride-on-Sweeper
• Now connect the power cable of the battery
chargr to a power supply socket.
• The charging cycle requires approx. ??.
hours if the battery was totally discharged
and to be recharged only by an Original Battery Charger (Original Manufacturer)
• The Original-Charger of the Manufacturer should be connected as it allows to maintain
the charging status/trickle charge and therefore always for the maximum capacity of the
batteries even after a long standing time.
• Make sure to only put your Ride-on-Sweeper into operation, if the battery charge status
Is sufficient. The Ride-on-Sweeper will switch off automatically if the batteries are dischar-
ged down to a critical level which could cause damage. (low voltage/deep discharge
disconnect) In such a case all consumer loads muts be completely disconnected and
switched OFF for one to two minutes. Thereafter they can be reconnected and then the
machine must driven immediatly to the charger for battery charging before damage
occurs. Strictly only use the drive motor (do not switch on brush/vacuum motor).
Operator panel
(without overhead emptying)
Description
Battery
LED display for
battery charge status
Battery charging indication
1
0
ON
OFF
ON
OFF
KS 1100 -
Englisch
Maintenance and Service
Charging
socket sweeper
