6
Safety devices
The Ride-On-Sweeper starts only when,
- the battery mains switch (emergency.-
Off) And the start switch with key is in
ON–position;
- Someone sits in the driving seat and
the seat contact is activated and addi-
tionally the accelarator pedal is
pressed down.
If the direction level (forwards/backwards)
at the steering column is in backwards
position, then an acoustic signal is activa-
ted. (optional)
Initial– Start-Up
The Ride-on-Sweeper is delivered as
standard version withou batteries and
without charger.
Optional:
The Ride-On-Sweeper can be delivered
with batteries and charger. The Ride-on-
Sweeper can be delivered with hydrau-
lisch overhead waste-box emptying.
Standard
• Open the transport packing.
• Remove the complete main cover. Lift
the main cover at the back and secure
the open position by using the support
holder.
•
Place the batteries inside the machine.
• Connect the batteries to the power
supply according to the Technical Data
and Circuit diagramm/Wiring plan.
• Close the main cover again and put
the support holder back into position.
• Mount the side brushes (page 13)
The Ride-On-Sweeper is now functional
and ready for operation.
• Drive the Ride-On-Sweeper out of the
transport packing down from the
wooden palett by using the ramp.
☞
Make sure to use the closed ramp.
The ramp must be designed
in such a way that not only the
front wheel, but also the rear-
drive-wheels can drive onto, over and
down and off the ramp.
If these instructions are not followed then
the mechanical functions of the Ride On-
Sweeper could be considerably damaged.
The power supply respectively the start
procedure must be interrupted in the
following cases:
Hence, the following is essential:
• The main cover can only be opened if
the Main switch is in OFF position, i.e.
the lever is turned in OFF position which
then allows free opening.
•
The side covers and other screwed /
bolted machine parts are only allowed
to be removed if the EMERGENCY-
OFF switch is turned to OFF position
and the key has been removed!
Optional:
• The Ride-On-Sweeper is equipped
with batteries.
• Open the transport packing.
• Open the main cover of the machine.
• Secure the open position of the main
cover with the cover support rod. The
cover has drill holes on the underside.
• Stick the cover support rod into the
drill hole.
• Connect the Plus-pole of the battery.
• Close the main cover.
• Mount the side brushes (see page 13)
• Drive the Ride-On-Sweeper over the
ramp and out of the transport packing.
☞
Make sure to use a closed ramp.
The ramp must be designed
in such a way that not only the
front wheel, but also the rear-
drive-wheels can drive onto, over and
down and off the ramp.
If these instructions are not followed then
the mechanical functions of the Ride On-
Sweeper could be considerably damaged.
The Ride-on-Sweeper is now functionable.
KS 1100 -
Englisch
