14
• Pull out the cylindrical brush out of
the machine and remove all wastes,
strings, tapes etc. from the cylindrical
mandrel.
Cylindrical brush fitting
• Push and slide the cylindrical brush
(D) under the machine.
☞
Pay attention to the driving/turning
direction of the cylindrical brush
when fitting it into the machine.
• At the cylindrical brush end there is
groove.
• Turn the cylindrical brush until the
pickup mandrel of the roller-rocker fits
in the groove of the cylindrical brush.
• Push and slide the roller rocker over
the threaded rod.
• Make sure, that the cylindrical brush
fits perfectly in the grooves on both
sides of the carrier and that all star
grips are fixed tightly.
Reattach the cover (C), lateral wall (B)
and lateral off- clothing (A).
Cylindrical brush
Cylindrical brush exchange
Dismantling the cylindrical brush
• Switch OFF the Ride-on-Sweeper and
remove the key.
• Turn-OFF the Main Switch and remove
the red key as well in order to prevent
unforeseen switching ON again.
• Pull up the lever for the cylindrical
brush.
• Locate and fix the lever in the top position.
• Unscrew the two screws with star grip
holding the machine-side-cover (A)
on the left side (driving view direction)
• Remove the machine-side-covers (A).
The cylindrical brush is held by total
three star grips/handles. Two star grips
with screw are for the front cover. One
star grip with screw holds the rubber-
flap/waste splash protection).
• Unscrew both front star grips and
remove
the
front
cover
(B).
• Loosen the top wing nut and
remove the brush roller cover with
rubber dirt apron the bottom (C).
KS 1100 -
Englisch
2 wing nut with side panel (A)
2 Star knobs with side wall inside (B)
1 wing nut cover with brush chamber
and rubber debris apron (C)
C
B
A
Maintenance and Service
