15
machine which is on the right-hand
side when looking in driving direction.
Further adjustment possibilities:
•
Remove the side cover of the machine
on the right hand side (driving direc-
tion view).
• Release the clamping screw.
• Put the cylindrical brush-support
sheet metal into the correct position.
• Refasten the clamping screw and
remount the side cover of the machine.
Reference note:
Original diameter of the Cylindrical Brush:
290 mm.
The brush must be replaced when the
diameter is below: 250 mm.
Cylindrical brush
Readjustment of the Cylindrical brush
Sweeping height / Sweeping range
The sweeping height/sweeping range of
the cylindrical brush is important to
achieve perfect surface cleaning results
and for the most effective use of the cylin-
drical brush.
Checking the sweeping height/range:
Drive the Ride-on-Sweeper on a surface
requiring cleaning. Switch-ON the cylind
-
rical brush motor but do not drive
onwards. Let the cylindrical brush work
1-2 minutes in standing position. Now lift
the lever of the cylindrical brush. Switch-
OFF the cylindrical brush motor and drive
a few metres forward. The sweep track left
behind on the floor is the Sweeping range.
Test-Cleaning
• Keep the safety cover closed
• Take a piece of chalk and draw a line
on the floor starting inbetween both
side brushes (centre-line) and leading
a few metres ahead of the machine.
• Lift-up the cylindrical brush and drive
slowly towards the chalk line and then
park the machine above this chalk
line.
• As soon as the sweeper stands on top
of the chalk line, lower the cylindrical
brush (release the lever and lead
downwards)
• Switch ON the motor for the cylindri-
cal brush and start cleaning. The cyli-
ndrical brush should clean about 2 cm
Adjustment
of
the
Sweeping
height/ Sweeping range
• Switch-OFF the Ride-on-Sweeper
• Pull the lever upwards which lifts the
cylindrical brush
• Open the main cover of the machine
• Secure the main cover in open-
position by using the support rod
• Now remove the side cover of the
KS 1100 -
Englisch
Maintenance and Service
1 Umdr
ehung
The suitable key for the
height Adjustment of the
cylindrical brush.
Hex nut
Hex bolt
Nut
Counter
nut
