Dolby Digital and Dolby Surround:
Dolby Digital and Dolby Surround are special sound
recording procedures that were originally developed for
film. To be able to also use these spatial sound effects at
your home, video tapes, TV broadcasting, CDs and LDs
have been manufactured with this technology.
In contrast to Dolby Surround Pro Logic, stereo channels
are also used for both surround speakers in Dolby Digital.
When buying DVD videos CDs, video cassettes, LDS and
music CDs look out for the
logo and the
logo. These logos mark all picture and sound me-
dia that contain recordings in Dolby-Pro-Logic Surround
and Dolby Digital quality.
VHS video cassettes that are only marked by the
logo do not contain the required information.
Manufactured under license from Dolby Laboratories Li-
censing Corporation. DOLBY, the Double-D symbol
and PRO LOGIC are registered trademarks of the Dolby
Laboratories Licensing Corporation.
This system is for a 5.1 decoder with 5 different audible
sound channels (right forward, left forward, middle, right
rear left rear) plus 1 subwoofer.
Speaker system »5.1 CH«
Before being able to configure and tune your speaker sy-
stem, the 5.1 CH setting must be made in AUDIO MODE
(STEREO is set at the factory)
Select
»
/
«
21 5.1 CH and confirm your selection with
»ENTER«
21. Press
»SETUP«
20 to quit the menu.
Configuring the speaker system
Depending on whether all six speakers are connected at
the »SPEAKER« 55 terminals or the »WOOFER LINE
OUT« 51 connector, the corresponding channels must be
switched on or off in the SPEAKER SETUP PAGE. Before
changing the basic settings, check which corrections are
required based on the following table.
Menü display
Factory settings
Centerbox
CENTER
ON
Surround speaker
REAR
ON
Subwoofer
SUBWOOFER
ON
Note:
When playing back sound on this system, the front
speakers must always be connected.
Turning on or off individual sound channels:
Switch on the device at the power switch
»POWER«
6.
Switch to DVD mode by pressing the
»DVD«
28 or
»SOURCE«
13 in DVD mode..
Press
»SETUP«
20.The main menu appears on the
screen. Select
SPEAKER SETUP
using
»
«
21.
Call up the
SPEAKER SETUP PAGE
by pressing
»ENTER«
21. For
AUDIO MODE
5.1 CH has to be set.
Depending on which speaker channel you want to switch
on or off, select with the » 5/6 « buttons 21 the sound
channel CENTER; REAR or SUBWOOFER.
Press
»
«
and highlight ON or OFF with
»
/
«
. Press
»ENTER«
21 to confirm the selection.
If you want to correct another sound channel then press
»
«
.Select the sound channel using
»
/
«
. Press
»
«
and switch them on or off using
»
/
«
. Press
»ENTER«
21 to confirm the selection..
To leave the menu, press
»SETUP«.
38
Configuring and operating the Surround System
AUDIO MODE
STEREO
CENTER
VSS
REAR
PRO LOGIC
SUBWOOFER
5.1 CH
CNTR DELAY
LT / TR
REAR DELAY
BASS MODE
MAIN PAGE
- - SPEAKER SETUP PAGE - -
STEREO DOWNMIX
SETUP MENU - - MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
DOLBY DIGITAL SETUP
PREFERENCES
EXIT SETUP
GOTO SPEAKER SETUP PAGE
- - SPEAKER SETUP PAGE - -
AUDIO MODE
STEREO
CENTER
VSS
REAR
PRO LOGIC
SUBWOOFER
5.1 CH
CNTR DELAY
LT / TR
REAR DELAY
BASS MODE
MAIN PAGE
SET AUDIO MODE
AUDIO MODE
CENTER
ON
REAR
OFF
SUBWOOFER
CNTR DELAY
REAR DELAY
BASS MODE
MAIN PAGE
- - SPEAKER SETUP PAGE - -
SETUP CENTER SPEAKER
SETUP MENU
SPEAKER SETUP
AUDIO MODE
DVD 534 HC - GB 25.06.2002 10:00 Uhr Seite 38
