Your Hipot tester
29
Leak Hi
– this is the upper limit for the leakage current.
Leak Lo
– this is the lower limit for the leakage current. It is used to
determine that a EUT is correctly connected.
Arc detect
– this shows the level set for the detection of any arc that
may occur in the EUT, during testing.
Start
– shows the action needed to initiate the test sequence. This
refers to the usage of the
ext
ernal safety guard switch
only
, the
ext
ernal
guard switch
and
the
Green
button or the
Green
button
only
.
Test status
– here this shows that the test is in the hold phase. This
part of the display is used to indicate what part of the test cycle is being
performed.
Elapsed
test time
– this is shown below the test status.
HV icon
– this is displayed to show that a voltage is being generated by
the tester, and if connected, will appear at the EUT.
The
right panel
of the display shows the output voltage and leakage
current or insulation resistance, depending on which test is being
applied.
The bar graphs are clearly marked, and include dashed lines to indicate
the limit points. At the top of each bar graph there is a numerical
display of the actual value.
Press Change Display
- allows the right panel to be changed to display
the readings via large high visibility DVM style displays, see below:
