Clare Controls 16-Channel NVR with PoE, User Manual

Page: 118 / 188

Chapter 9: Network Settings
Network Video Recorder User Manual 107
Configuring NTP server
Configure a Network Time Protocol (NTP) server on your NVR to ensure the
accuracy of the system date and time.
To configure an NTP server:
1. Enter the Network Settings interface (Menu > Configuration > Network).
2. Click the NTP tab to enter the NTP Settings interface.
3. Check the Enable NTP check box to enable it.
4. Configure the following NTP settings.
Interval: Time interval between the two synchronizing actions with NTP
server. The unit is minute.
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
5. Click Apply to save and exit the interface.
Note: The time synchronization interval is set from1 to 10080 minutes. The
default value is 60 minutes. If the NVR is connected to a public network, you
should use an NTP server that has a time synchronization function, such as
the server at the National Time Center (IP Address: 210.72.145.44). If the
NVR is setup in a customized network, use NTP software to establish an NTP
server used for time synchronization.
Configuring SNMP
You can use SNMP protocol to get device status and parameters-related
information.
To configure SNMP:
1. Enter the Network Settings interface. Menu > Configuration > Network.
2. Click the SNMP tab to enter the SNMP Settings interface.