SM-P00077-A/3
1. PRODUCT OVERVIEW
3
2020-04-15
No.
Part name
Description
1
Lead wire
Wire which has no polarity.
2
Electrical component cover
Cover provided with a power indicator on the top surface which lights green while the
coil is energized (only for E-type and A-type connectors).
3
Coil assembly
Coil assembly which varies depending on the type of electrical connection and voltage
selected for the valve. Not interchangeable with No. 36.
4
Manual protection cover
Cover which prevents accidental operation of the manual override and is opened to
operate the manual override.
5
Manual override
Manual operation device which has both locking and non-locking overrides.
6
Single valve
Valve equipped with a mechanism which opens/closes an air passage.
7
Single valve mounting screw
Screw used for securing a single valve to various bases (2 screws provided for each
valve).
8
Subplate
Subplate which comes assembled to a base piping type single valve.
9
Piping port
Port provided for supply, indicated by 1(P); for exhaust, indicated by 3(R2) or 5(R1); for
output, indicated by 2(B) or 4(A).
10
Fitting
Cartridge type push-in fitting which can be replaced.
11-1
Fitting stopper pin
Pin used for securing a cartridge type fitting.
(4GA R Series)
11-2
Fitting stopper plate
Plate used for securing a cartridge type fitting. Not interchangeable with No. 17.
(4GD R Series)
12
Pipe adaptor
Adaptor which comes assembled to a body piping type single valve.
13
Mounting hole
Hole used for direct mounting.
14
Mounting plate
Plate used for vertical mounting of a body piping type single valve.
15
Manifold base
Metal base manifold provided with multiple piping ports.
16
Masking plate
Plate replaced by a single valve when adding a valve.
17
Fitting stopper plate
Plate used for securing a cartridge type fitting.
Not interchangeable with No. 11-2.
18
Electrical component block
Component block which stores and secures a printed circuit board mounted with PCB
connectors.
19
Wiring duct
Duct provided for protecting cables contained.
20
DIN rail
Rail which complies with DIN standard (German Industry Standard) and is used for
mounting a solenoid valve.
21
DIN rail mounting screw
Screw used for securing the entire manifold in place on the DIN rail and located at both
ends of the base.
22
Holder
Holder used together with the DIN rail mounting screw (only for 4G2/4G3).
23
Spare cable
Cable used when adding a valve.
24
Terminal block
Connector block provided with a set of terminals for controlling the manifold valves.
25
Cover
Cover which is opened to work on wiring and must be closed before energization in
order to avoid an electric shock.
26
Terminal block layout
Diagram which indicates the layout of the terminal block and on which notes can be
written.
27
D-sub 25-pin connector
Connector provided with a set of terminals for controlling the manifold valves.
28
Mounting screw
Screw used for securing the connectors (screw size is M2.6).
29
Connector rotation button
Button used for changing the direction of the connector wiring upward or sideways.
Pressing in the button releases the lock and allows the connector to rotate.
Rotating the connector to a predetermined position pushes out the button and locks the
connector.
30
Power supply terminal block
Terminal block used when an external power supply is required.
31
Power polarity marking
Marking which indicates the power polarity (
▽
mark indicates the ground side).
32
Power indicator
Indicator which lights up when power is supplied with right polarity.
