Civemasa Implementos Agrícolas
21
CRO 4.0
Adjustments and operations
• It is important to give finish working in the cut
parts. For this purpose, use a filer. Soon after, remove
the filling and lubricate the "male" with a fine layer of
grease.
• Decrease the length of both protective covers
using the cut tubes as a measure and clean the cut
residues.
• Assemble the cardan shaft according to the
instructions on the next page.
• When using another tractor, verify the length of
the cardan shaft again.
• The chains of the protective covers should be
fastened to both equipment and tractor, so that they
will not get loose during maneuvers.
NOTE The contact surface between the hub and the bar must never be smaller than
1/3 of its total length.
Proper cardan assembly
When assembling the cardan, note the correct alignment at both ends. The wrong
assembly causes excessive vibration and damages to the transmission, thus reducing the
lifetime of the set.
Note the internal forks alignment
Garfos internos desalinhados
Unaligned internal forks
Correct assembly
Correct assembly
Incorrect assembly
Incorrect assembly
1/3
1/3
2/3
2/3
