Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 234 -
CT-D151
• Setting MSW 1 (a=1)
n
b (Set Value)
Function
1
48 (Default)
Reports the power on.
49
Does not report power on.
2
48 (Default)
Sets input buffer capacity to 4K bytes.
49
Sets input buffer capacity to 45 bytes.
3
48 (Default)
Sets input buffer full and offline to be Busy.
49
Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
49
At the occurrence of receiving error, ignores the data.
5
48 (Default)
Disables CR (0DH).
49
Enables CR (0DH).
6
48 (Default)
Reserved
7
48 (Default)
Does not reset at serial I/F pin 6.
49
Resets at serial I/F pin 6.
8
48 (Default)
Does not reset at serial I/F pin 9.
49
Resets sat serial I/F pin 9.
* With MSW1-2, With serial I/F, 45 bytes are enabled only when DMA control
(MSW7-6) is disabled.
• Setting MSW 2 (a=2)
n
b (Set Value)
Function
1 49 (Default)
Reserved
2
48
Disables auto cutter.
49 (Default)
Enables auto cutter.
3
48 (Default)
Enables stored printing.
49
Disables stored printing.
4
48
Immediately after digit reaches full, line-feed is taken.
49 (Default)
Immediately after digit reaches full, data wait is taken.
5
48 (Default)
After cover close and PE recovery, prints as it is.
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6 48 (Default)
Reserved
7 48 (Default)
Reserved
8
48 (Default)
Enables PNE.
49
Disables PNE.
• Setting MSW 3 (a=3)
n
b (Set Value)
Function
1
48 (Default)
After clearing cutter error, can be restored by Feed SW.
49
After clearing cutter error, cannot be restored by Feed SW.
2
48
PE is outputted at the time of PNE detection.
49 (Default)
PE is not outputted at the time of PNE detection.
3
48 (Default)
Reserved
4
48 (Default)
Reserved
5
48 (Default)
Reserved
6
48 (Default)
Reserved
7
48 (Default)
Sets EPSON compatible mode.
49
Sets CBM1000-compatible mode.
8
48 (Default)
Sets cover open error during printing to be auto recovery
error.
49
Sets cover open error during printing to be recoverable
error.
• Setting MSW 4 (a=4)
n
b (Set Value)
Function
1
48 (Default)
Reserved
2
48 (Default)
Reserved
3
48
Feed & Cut at TOF disabled.
49 (Default)
Feed & Cut at TOF enabled.
4
48 (Default)
Reserved
5
48 (Default)
Reserved
6
48 (Default)
Reserved
7
48 (Default)
Reserved
8
48
Cut method is determined according to the cut command.
49 (Default)
Partial cut is performed regardless of cut command. (full
but by command: enabled).
