Citizen CT-D150, Command Reference Manual

Page: 127 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 126 -
CT-S801(II) / CT-S851(II) / CT-S601(II) / CT-S651(II)
(1) Printer status (When n = 1 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
2
Status of pin 3 of drawer kick-out connector = L 00H 0
Status of pin 3 of drawer kick-out connector = H 04H 4
3
Online status 00H 0
Offline status 08H 8
4 Fixed 10H 16
5
Not waiting online recovery 00H 0
Waiting online recovery 20H 32
6
FEED switch is not pressed 00H 0
FEED switch is pressed 40H 64
7 Fixed 00H 0
(2) Status caused by an offline condition (When n = 2 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
2
Cover closed 00H 0
Cover open 04H 4
3
Not in paper feed state triggered by FEED
switch
00H 0
In paper feed state triggered by FEED switch 08H 8
4 Fixed 10H 16
5
Printing is not stopped because of “paper out”
state
00H 0
Printing is stopped because of “paper out” state 20H 32
6
Error not occurred 00H 0
Error occurred 40H 64
7 Fixed 00H 0
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end Sensor
is enabled by ESC c 4. At this time, bit 5 = 1.
(3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
2
No Mechanism error occurred.
No BM/Label
detection error
occurred.(only when BM/Label paper is
selected)
00H 0
A Mechanism error occurred.
A BM/Label detection error occurred.(only
when BM/Label paper is selected)
04H 4
3
Auto cutter error not occurred 00H 0
Auto cutter error occurred 08H 8
4 Fixed 10H 16
5
Unrecoverable error not occurred 00H 0
Unrecoverable error occurred 20H 32
6
Auto recovery error not occurred 00H 0
Auto recovery error occurred 40H 64
7 Fixed 00H 0
Bit 2: In case of MSW3-8=ON, it is generated by cover-open.
At BM/Label model, it is generated by BM/Label-error.
Bit 3: If this error occurred because of a paper jam, for example, remove
the cause of the error, and then DLE ENQ n (1
≤n≤2) can be used to
recover from the error. However, it is not possible to recover from any
error due to a circuit problem (e.g., broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.