Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 142 -
(2) 2nd byte (Error occurrence information)
Bit
Status
Hex.
Decimal
0
Undefined
-
-
1
Undefined
-
-
2
No Mechanism error occurred.
No BM detection error occurred.(only when BM paper is
selected)
No presenter error occurred. (only when presenter function is
enabled.)
00H
0
A Mechanism error occurred.
A BM detection error occurred.(only when BM paper is selected)
A presenter error occurred (only when presenter function is
enabled.)
04H
4
3
Auto cutter error not occurred
00H
0
Auto cutter error occurred
08H
8
4
Unused
00H
0
5
Unrecoverable error not occurred
00H
0
Unrecoverable error occurred
20H
32
6
Auto recovery error not occurred
00H
0
Auto recovery error occurred
40H
64
7
Unused
00H
0
*Bit 2:
In case of MSW3-8=ON, i t is generated by cover-open.
At BM/Label model, it is generated by BM/Label-error.
At presenter model, it is generated at presenter error.
*Bit 3: If this error occurred because of a paper jam, for example, remove the cause of the error, and then
DLE ENQ n (1 n 2) can be used to recover from the error. However, it is not possible to recover from
any error due to a circuit problem (e.g., broken wire).
*Bit 6: If a head overheat error is detected, the printing is stopped until the head temperature falls. At this
time, bit 6 = 1.
(3) 3rd byte (Paper Sensor information)
Bit
Status
Hex.
Decimal
0, 1
Paper found by Paper Near-end Sensor
00H
0
Paper not found by Paper Near-end Sensor
03H
3
2, 3
Paper found by Paper-end Sensor
00H
0
Paper not found by Paper-end Sensor
0CH
12
4
Unused
00H
0
5
Undefined
-
-
6
Undefined
-
-
7
Unused
00H
0
