20
(Optional) Connecting Your Cisco SPA 303 to the Wireless Network
You can use the Cisco WBP54G Wireless-G Bridge for Phone Adapters to connect the IP phone
to a Wireless-G network instead of the wired local network.
NOTE
Cisco does not recommend connecting a PC to the phone when it is operating
wirelessly.
To connect your phone to the Cisco WBP54G:
STEP 1
Configure the Cisco WBP54G using the Setup Wizard. See the instructions in the
Wireless-G Bridge for Phone Adapters Quick Installation Guide, available on cisco.com.
STEP 2
During the Setup Wizard process, connect the Ethernet network cable of the
WBP54G to the back of the IP phone base station into the slot marked “SW.
STEP 3
Connect the power cable of the WBP54G to the power port on the IP phone
base.
STEP 4
Plug the IP phone power adapter into the power port of the WBP54G.
STEP 5
Plug the other end of the IP phone power adapter into an electrical outlet.
(Optional) Installing the Cisco SPA 303 Stand
NOTE
Do not attach the desk stand if you want to mount the phone to the wall.
STEP 1
Connect the phone stand by lining up the tabs on the stand with the slots on the
phone body.
STEP 2
Slide the bottom tabs into the lower slots on the phone body (labeled 1 in
Figure 3
) and lightly press down on the stand. It should easily slide into the upper stand
slots. Do not force.
Summary of Contents for SPA 303g
