12-2
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-06
Chapter 12 Configuring Smartports Macros
Configuring Smartports Macros
Configuring Smartports Macros
You can create a new Smartports macro or use an existing macro as a template to create a new macro
that is specific to your application. After you create the macro, you can apply it globally to a switch or
to a switch interface or range of interfaces.
These sections contain this configuration information:
•
Default Smartports Macro Configuration, page 12-2
•
Smartports Macro Configuration Guidelines, page 12-2
•
Creating Smartports Macros, page 12-4
•
Applying Smartports Macros, page 12-5
•
Applying Cisco-Default Smartports Macros, page 12-6
Default Smartports Macro Configuration
There are no Smartports macros enabled.
Smartports Macro Configuration Guidelines
Follow these guidelines when configuring macros on your switch:
•
When creating a macro, do not use the
exit
or
end
commands or change the command mode by using
interface
interface-id
. This could cause commands that follow
exit
,
end
, or
interface
interface-id
to execute in a different command mode.
•
When creating a macro, all CLI commands should be in the same configuration mode.
•
When creating a macro that requires the assignment of unique values, use the
parameter
value
keywords to designate values specific to the interface. Keyword matching is case sensitive. All
matching occurrences of the keyword are replaced with the corresponding value. Any full match of
cisco-phone
Use this interface configuration macro when connecting a desktop device such as a
PC with a Cisco IP Phone to a switch port. This macro is an extension of the
cisco-desktop
macro and provides the same security and resiliency features, but with
the addition of dedicated voice VLANs to ensure proper treatment of delay-sensitive
voice traffic.
cisco-switch
Use this interface configuration macro when connecting an access switch and a
distribution switch or between access switches connected using small form-factor
pluggable (SFP) modules.
cisco-router
Use this interface configuration macro when connecting the switch and a WAN
router.
cisco-wireless
Use this interface configuration macro when connecting the switch and a wireless
access point.
1.
Cisco-default Smartports macros vary depending on the software version running on your switch.
Table 12-1
Cisco-Default Smartports Macros (continued)
Macro Name
1
Description
