39-62
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-06
Chapter 39 Configuring IP Unicast Routing
Configuring BGP
Based on the community, you can control the routing information to accept, prefer, or distribute to other
neighbors. A BGP speaker can set, append, or modify the community of a route when learning,
advertising, or redistributing routes. When routes are aggregated, the resulting aggregate has a
COMMUNITIES attribute that contains all communities from all the initial routes.
You can use community lists to create groups of communities to use in a match clause of a route map.
As with an access list, a series of community lists can be created. Statements are evaluated until a match
is found. As soon as one statement is met, the test stops.
To set the COMMUNITIES attribute and match clauses based on communities, see the
match
community-list
and
set community
route-map configuration commands in the
“Using Route Maps to
Redistribute Routing Information” section on page 39-99
.
By default, no COMMUNITIES attribute is sent to a neighbor. You can specify that the COMMUNITIES
attribute be sent to the neighbor at an IP address by using the
neighbor send-community
router
configuration command.
Beginning in privileged EXEC mode, follow these steps to create and to apply a community list:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip community-list
community-list-number
{
permit
|
deny
}
community-number
Create a community list, and assign it a number.
•
The
community-list-number
is an integer from 1 to 99 that
identifies one or more permit or deny groups of communities.
•
The
community-number
is the number configured by a
set
community
route-map configuration command.
Step 3
router bgp
autonomous-system
Enter BGP router configuration mode.
Step 4
neighbor
{
ip-address
|
peer-group name
}
send-community
Specify that the COMMUNITIES attribute is sent to the neighbor at this
IP address.
Step 5
set comm-list
list-num
delete
(Optional) Remove communities from the community attribute of an
inbound or outbound update that match a standard or extended
community list specified by a route map.
Step 6
exit
Return to global configuration mode.
Step 7
ip bgp-community new-format
(Optional) Display and parse BGP communities in the format AA:NN.
A BGP community appears in a two-part format 2 bytes long. The
Cisco-default community format is NNAA. In the most recent RFC for
BGP, a community takes the form AA:NN, where the first part is the
autonomous-system number and the second part is a 2-byte number.
Step 8
end
Return to privileged EXEC mode.
Step 9
show ip bgp community
Verify the configuration.
Step 10
copy running-config startup-config
(Optional) Save your entries in the configuration file.
