5-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 5 Upgrading the 5-GHz Radio Module
Installing a 5-GHz Radio Module
Attaching the Compliance Label
There are three places on the 1200 series access point dedicated to compliance labels, one for the product
compliance label and two for the radio compliance labels. The label locations are shown in
Figure 5-6
.
Figure 5-6
Access Point Compliance Label Locations
The product compliance label always occupies the top space (location 1). The two spaces below the
product compliance label (locations 2 and 3) contain the radio compliance labels. Whether or not
locations 2 or 3 contain labels depends on how your access point is configured. For example, the access
point could have two radio compliance labels (one for each radio device installed), or the access point
could have only a product compliance label, depending on how it was ordered.
Make sure that your access point has the correct labels after you install or upgrade its radio configuration
so that it will be in compliance with regulations in your country.
The AIR-MR21A and AIR RM22A radio upgrade kits ship with the following labels for the 1200 series
access points:
•
1200 series product compliance label (AIR-AP1210-x-K9)
•
1200 series radio compliance label (AIR-RM21A-x-K9 or AIR-RM22A-x-K9)
Table 5-1
shows where to place the labels on your 1200 series access point, based on the model you are
upgrading. Follow these steps to place the labels correctly:
1
Product compliance label
3
Radio compliance label
2
Radio compliance label
1
2
3
103640
