3-2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 3 Mounting Instructions
Overview
Overview
You can mount the access point on any of the following surfaces:
•
Horizontal or vertical flat surfaces, such as walls or ceilings
•
Suspended ceilings
The access point ships with a detachable mounting bracket and the necessary mounting hardware.
Because it is detachable, you can use the mounting bracket as a template to mark the positions of the
mounting holes for your installation. You then install the mounting bracket and attach the access point
when you are ready. Refer to
Figure 3-1
to locate the various mounting holes for the method you intend
to use.
Figure 3-1
Mounting Bracket
Note
The 1200 series access point provides adequate fire resistance and low smoke-producing characteristics
suitable for operation in a building's environmental air space (such as above suspended ceilings) in
accordance with Section 300-22(C) of the National Electrical Code (NEC).
Caution
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
building’s environmental air space; no other power injectors or power modules have been tested to UL 2043
and they should not be placed in a building’s environmental air space, such as above suspended ceilings.
Note
If you plan to mount the access point in environmental air space and will upgrade to a 5-GHz radio, Cisco
recommends that you mount the access point horizontally with its antennas pointing down. Doing so will
result in the access point complying with regulatory requirements for environmental air space after the
5-GHz radio is installed.
1
Access point mount
5
Locking detent
2
Cable tie points
6
Wall cable access
3
Ceiling mount holes
7
Suspended ceiling cable access
4
Access point mounts
8
Security hasp
1
5
4
6
7
3
8
2
3
4
65863
2
