Cisco AGS+, Hardware Installation And Maintenance

Page: 91 / 146

Applique
and Cable
Pinouts
Safety
Warnings
and Requirements
for the G.703
These warning
notices apply
to the
Input
Port the port
marked
SAFETY WARNING
see
instructions
for
use
Warning
The
port
marked
SAFETY WARNING
see instructions for
use
does not provide
isolation sufficient to satisfy
the requirements of BS6301
apparatus
connected
directly
to this port
should
either
have been approved
to
BS63O1
or
have
previously
been
evaluated
against British
Telecommunications
PLC
Post
Office
Technical
Guides
or
26 and
given permission to
attach
Any other usage
will
invalidate
the
approval
of
the Applique
Warning Interconnection of the applique Input Port
the
port
marked
SAFETY WARNING
see
instructions for
use
directly or
by way of
any
other apparatus with
ports
on other apparatus
7/
marked
or not so
marked may
produce
hazardous conditions on
the
network
Users should seek
advice
from
competent engineer
before
making such connection
Warning
The
applique is approved as Independent
of
Host As such
the
applique is only
approved
for use with
host
and
with host attachments
that are either
type approved
in their
own
right
or if 7/
supplied
after
1st
March
1989
are
covered by the terms of
the
General
Approval number
NS/G/1234/J/100003 Host
supplied under
the terms of the General
Approval number
NS/G/12341J1100003
satisfies
the conditions of
the
paragraphs
above
Warning
The
applique
must
not be modified
in
any
way Any
form
of modification invalidates the
approval for
connection
and
the warranty of the unit
The
applique approval label
must
be
visible
externally
The
approval label
must
not be detached
from
the applique nor attached
to
the host
The
terms of the approval
require that
there
must be
minimum
distance
mm
between
the applique
and any
other
part
of
the
host
including
other appliques This condition
is
met by
default
when
the
applique is installed in
chassis
in
accordance with the instructions
Warning
If voltages greater than
250V
are present in the host users should
refer to competent
safety
engineer for
advice
It is
condition of the approval
that copy
of these user
instructions
and
7/
safety
warnings
must
be supplied with
the
host Failure
to provide the applique user instructions
with
the host
will
invalidate the applique approval Failure
to install
the applique in accordance with these
instructions will
invalidate
the
approval
If
you experience
difficulties
or are
iii
any
doubt contact
customer service representative
A4 AGS
Hardware
Installation
and Maintenance