Cisco 7902G - Unified IP Phone VoIP, Administration Manual

Page: 166 / 208

Appendix A Additional Configuration Methods and Parameters
Configuration Parameters
A-18
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
OpFlags Enables or disables various
features on the phone. Bit map, as follows:
•
Bit 0—If 1, ignore the DHCP-assigned TFTP file
name and use the following file name when using
TFTP for configuring: ff
xxxxxxxxxxxx
(Cisco Unified IP Phone 7902G) or
ld xxxxxxxxxxxx (Cisco Unified IP Phone 7905G
and 7912G), where each xx is the two-digit
lowercase hexadecimal representation of each
integer in the phone’s MAC address.
•
Bit 1—If the phone is configured to use static IP
(that is, the router and gateway addresses are
statically assigned), set to 1 to prevent probing at
boot time. Otherwise, the phone probes the
route/gateway address to determine if there is
network connectivity.
•
Bit 2—Reserved for future use.
• Bit 3—If 1, do not request DHCP option 150 in the
DHCP DISCOVERY message.
•
Bit 4—If 1, assume operation under VLAN. (The
VLAN ID is specified in the VLANSetting
parameter.)
•
Bit 5—If 1, turn off VLAN IP encapsulation.
•
Bit 6—If 1, do not perform CDP
1
discovery.
•
Bit 7—If 1, do not allow web configuration of the
phone.
•
Bit 8—Not used on the Cisco Unified IP Phone
7905G. On the Cisco Unified IP Phone 7902G, if
set to 1, the IP address cannot be refreshed through
an HTTP request.
• Bit 9—Not used on the Cisco Unified IP Phone
7905G. On the Cisco Unified IP Phone 7902G, if
set to 1, the IP address cannot be reset through an
HTTP request.
The default value is 0x00000002.
Table A-5 Network Parameters (continued)
Parameter Description Usage