4-5
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
Replacing a Power Supply
Figure 4-3
Fan Assembly
Step 3
Within one minute, insert the new fan with the surface marked “TOP” facing up and verify that the latch
is engaged.
Step 4
Check the power LED to verify that the new fan is receiving power.
Note
If a fan alarm occurs and you power down the WAVE appliance to replace the fan, you must use the
clear
bmc event-log
global configuration command and then reboot to clear the alarm.
Replacing a Power Supply
The WAVE appliance supports two power supply assemblies that are hot-swap capable.
Power supply assemblies can only be inserted in one orientation.
Note
Power supply assemblies must be inserted and can only function with the surface marked “TOP” facing
up.
Caution
To maintain proper system cooling, do not operate the appliance for more than 1 minute without either
a power supply or a filler panel installed in each bay.
To replace a power supply assembly, follow these steps:
Step 1
Review the information in the
“Safety Warnings and Cautions” section on page 2-1
and the
“Safety
Guidelines” section on page 2-2
.
Step 2
Remove the power cord from the power supply.
Note
When more than one power supply assembly is present, load-sharing is supported. If one loses
power, the second power supply takes over.
246554
1
2