3-18
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 3 Configuring Ports and Interfaces
Configuring Dynamic Interfaces
Step 4
Enter these commands to configure dynamic interfaces:
•
config interface create
operator-defined-interface-name
{
vlan-id
|
x
}
Note
Enter a non-zero value for the VLAN identifier. Tagged VLANs must be used for dynamic
interfaces.
•
config interface address
operator-defined-interface-name
ip-addr ip-netmask
[
gateway
]
•
config interface vlan
operator-defined-interface-name
{
vlan-id
|
0
}
•
config interface port
operator-defined-interface-name
physical-ds-port-number
•
config interface dhcp
operator-defined-interface-name
ip-address-of-primary-dhcp-server
[
ip-address-of-secondary-dhcp-server
]
•
config interface
operator-defined-interface-name
quarantine enable
Note
Use this command if you want to configure this VLAN as unhealthy. Doing so causes the
data traffic of any client that is assigned to this VLAN to pass through the controller, even
if the WLAN is configured for local switching. This command is generally used for clients
that are associated to a hybrid-REAP access point and the access point’s controller is
configured for network access control (NAC). See
Chapter 12
for more information on
hybrid REAP.
•
config interface acl
operator-defined-interface-name
access-control-list-name
Note
See
Chapter 5
for more information on ACLs.
Step 5
Enter
save
config
to save your changes.
Step 6
Enter
show interface detailed
operator-defined-interface-name
and
show interface summary
to verify
that your changes have been saved.
Note
If desired, you can enter
config interface delete
operator-defined-interface-name
to delete a dynamic
interface.
