Cirris Signature 1000HN, User Manual

Page: 51 / 86

Section 11: Rework and Guided Assembly / Rework instructions
1000HN User’s Guide / page 51
Removing shorts within a net
If the analyzer detects a short, follow these steps:
1. Press
Display/Print
once to put the analyzer into rework mode. The analyzer will
prompt
Break JX-XX
, where X indicates the adapter position and the pin num-
ber. Break all connections indicated in the display
2. When you break a connection, the analyzer will prompt the next short. When all
the shorts have been broken, the analyzer will prompt the net and point to which
you should connect JX-XX. Connect JX-XX to the point indicated in the display.
3. Once you’ve corrected all the shorted connections, the analyzer will either
prompt
Good Cable
, or
Connect JX-XX
. If the analyzer prompts
Break JX-
XX
, you have created another short. Go back to step 2 and try again.
Note
: The
B R E A K J X -X X
Break JX-XX
C O N N E C T JX -X X
C o n n e c t JX -X X