Cirris Signature 1000HN, User Manual

Page: 50 / 86

Section 11: Rework and Guided Assembly / Displaying multiple interconnected pins
1000HN User’s Guide / page 50
Displaying multiple
interconnected pins
Up to three different pins can be displayed at the same time. If more than three pins
are interconnected, a plus sign (+) will appear in the lower right-hand corner of the
display. To view any additional interconnections, press
Display/Print
.
Using the probe to
identify an open
circuit
Using the probe, the analyzer can detect which end of an interconnection has an open.
When the analyzer prompts an open, use the sharp metal tip of the probe to pierce the
insulation of the wire that should connect between the two pins. The pin shown in the
display is the pin that has a good connection to the wire. The pin that is not displayed
is the open.
Rework
instructions
Before you begin reworking a cable assembly, remember these things:
• If you have a printer connected to your analyzer, either turn it off or
disconnect it.
• When the analyzer displays errors, pressing
Display/Print
once will put
the analyzer into rework mode. If you press
Display/Print
twice, the
analyzer will just prompt all the errors it detects.
Please see next page...
P R O B E O N J 1-09
J 1-10 J1 -11
+
Plus sign here indicates
more than three points
are interconnected.
Press to display
additional points
P R O B E O N J 3-02
J1-01
J3-02
Open