Cirris Signature 1000HN, User Manual

Page: 14 / 86

Section 1: Work With the Hardware / Adding a printer
1000HN User’s Guide / page 14
4. Gently align the pins on the new EPROM with the holes in the socket.
5. Carefully push the new EPROM down into the socket using even pressure. Be
careful not to misalign or bend the pins!
6. Gently lower the microprocessor assembly back into the box. Replace the spacer
plate, then lock the twistlock fasteners. Your unit is reassembled.
Adding a printer The 1000HN works with almost any printer that has an Epson/Centronics parallel
interface.
WARNING!! Connecting the analyzer to a printer with an RS-232 serial
interface will cause serious damage to the analyzer, and is not covered by your fac-
tory warranty.
To connect the printer, use a standard Epson/Centronic parallel interface cable,
readily available from almost any PC dealer. Plug one end of the cable into the
printer, and the other end into the analyzer’s parallel printer socket as shown in the
photo.
How do I know if I
have a parallel
printer?
To see if you have a parallel printer, look for the parallel connector on the printer.
Printers usually have a parallel interface located in back. Many printers have both a
Gently place the new EPROM on the socket, and align the
pins. Be careful not to bend the pins!
Socket
New EPROM
Plug the printer
in here