Circutor AFQevo, Instruction Manual

Page: 77 / 102

77
Instruction Manual
AFQevo
Table 32:Modbus memory map: Filter parameters (Table 2)�
Parameter L1 L2 L3 LN Units
Current in the filter A3 - A2 A5 - A4 A7 - A6 A9 - A8 [Hi] + [Low] A with 1 decimal
Phase – neutral voltage AA AB AC - V with 1 decimal
% of filter power used D8 D9 DA - %
Voltage THD BA BB BC - % with 1 decimal
Table 33:Modbus memory map: Filter parameters (Table 3)�
Parameter Address Description
AFQevo serial no.
(3)
2710 - 2711 Hi [10] + Low [11] serial no.
DSP software version 10C -
HMI software version 1C3 -
(3)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
8.2.2.4.- AFQevo filter messages
Table 34:Modbus memory map: Filter messages (Table 1)�
Parameter Address
Device status
(4)
110
Bit Description Status
0x0001 Stop
1 : ON
0 : OFF
0x0002 Start
0x0004 Reset alarms
(4)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
Table 35:Modbus memory map: Filter messages (Table 2)�
Parameter Address
Alarm messages 105 (Hi value), 106 (Low value)
Bit Description
0x00000000 There are no alarms
0x00000001 DC bus overvoltage alarm
0x00000002 L1 overcurrent alarm
0x00000004 L2 overcurrent alarm
0x00000008 L3 overcurrent alarm
0x00000010 L1 overvoltage alarm
0x00000020 L2 overvoltage alarm
0x00000040 L3 overvoltage alarm
0x00004000 Temperature IGBT alarm
0x00008000 Temperature Inductor alarm
0x00010000 Initial Conditions Error
0x00020000 Resonance Alarm
0x00100000 Contactor faults