Guangdong Chuangda Automatic Equipment Co.,Ltd.
49
/
63
Add: D11, New Lighting Source Industrial Basis, Nanhai District, Foshan City, Guangdong Province
Tel: +86- 0757-82629566 82629546 82326616 Fax: +86- 0757-82622156
Notes about the "Jog" key:
If the jog key is pressed when the machine is shutdown, the machine will run slowly or stop. If the jog key is
pressed during normal operation, the machine will run slowly, and the machine will stop after the jog key is
released. If the jog key and start key are pressed at the same time, the machine will run slowly; if the jog key if
released firstly, the machine automatically start normal operation. During jogging, the fan cannot be started;
whether the gas terminal outputs voltage at this time will depend how the power supply is set
Adjust the Running Speed of the Machine
Press
key to unlock the speed control function, speed
to speed up, press
to slow down, pay
attention to the operation speed of the machine when adjusting the speed.
(Fig. 70)
If no speed adjustment is made, the computer will stop the speed regulation function two minutes later to
prevent false triggering, as shown in the Fig71. below, press the
【
speed regulation
】
key on the control panel to
open the speed function.
(Fig. 71)
Stop Machine Operation
The machine may stop during normal operation if the STOP key is pressed or any abnormal circumstance occurs.
After reaching the count (the knitting number is equal to the set number), the knitting work is completed, the
machine will automatically stop, and the screen will display the count menu (Figure 59), while the valve is closed,
and the fan and pump are stopped.
Needles:
Speed:
Set revolutions:
Knitting revolutions:
Cumulative revolutions:
Shift:
Knitting number:
Speed regulation function is enabled, press the up and down arrows to adjust the speed!
1. Pattern type
4. Memory function
2. Check
5. Reset
3. Count
6. Next page tips
Normal operation
Needles:
Speed:
Set revolutions:
Knitting revolutions:
Cumulative revolutions:
Shift:
Knitting number:
Speed regulation function is disabled, press [FUN] key to enable!
1. Pattern type
2. Check
3. Count
4. Memory function
5. Reset
6. Next page tips
Stop running
