Christini AWD 250, Service Manual

Page: 23 / 124

Page 22
Clutch/Exhaust
CLUTCH CLUTCH CLUTCH CLUTCH
The clutch lever should have a maximum play of 3 mm. This
margin increases with the wear on the clutch plate.
To adjust, proceed as follows:
- Use bolt A to adjust the lever’s range of movement to the
rider’s convenience.
- Adjust the play of the lever using bolt B.
WARNING WARNING WARNING WARNING
- Maintain the clutch lever with the play shown, otherwise the performance and useful life of the clutch
may be adversely affected.
- This model uses mineral oil GRO ULTRA 5 for the clutch hydraulic circuit.
- Tank C must not be filled with brake liquid.
EXHAUST SYSTEM
EXHAUST SYSTEM EXHAUST SYSTEM
EXHAUST SYSTEM
The exhaust and the muffler reduce the noise and send gases
away from the rider. If the exhaust is badly damaged, dented,
cracked or rusted, replace it with a new one. Replace the muffler
fiber if the exhaust noise becomes too loud or if the engine per-
formance drops.
Muffler replacement
Muffler replacement Muffler replacement Muffler replacement
- Remove the retaining screws of the right side number-posting
cover.
- Remove the retaining screws (A) of the muffler (B) and remove
the muffler towards the rear.
- Separate the silencer from the joint (see arrow).
- Replace the muffler and reinstall the assembly.
Changing the silencer packing
Changing the silencer packing Changing the silencer packing
Changing the silencer packing
- Remove all three screws.
- Remove the inside core of the muffler.
- Replace the muffler fiber by wrapping it around the inner tube.
- Reinstall the assembly.
-(A). Screw.
-(B). Silencer.