Christini AWD 250, Service Manual

Page: 47 / 124

Page 46
Note:
Note: Note:
Note: Before performing this test, make sure the AWD Clutch is set
correctly.
•
Place the bike on a stand and make sure that the wheels are not
touching the ground.
•
Turn the AWD switch to the on position and check to make sure
the AWD is engaged.
•
Center the handlebars.
•
Hold down the front and rear brakes.
•
Turn handlebars to the left
left left
left and back to center. There should be
steering resistance from the AWD system when this is performed.
•
Release brakes and center handlebars.
•
Hold down front and rear brakes again and turn handlebars to the
right
right right
right and back to center. There should be steering resistance
from the AWD system.
•
If no resistance is felt, or there is only resistance in one direction,
check the front wheel to ensure the sprag bearings are not slip-
ping or damaged. See “Front Wheel Service” section.
Front Wheel Sprag Test