Christini AWD 250, Service Manual

Page: 120 / 124

Page 119
Front forks feel sticky
•
Clean and lube fork seals.
•
Check to make sure forks are not twisted in triple
clamps.
•
Lube front spline shafts with grease.
•
If this does not help, pull down dust boot and check
spline shaft for damage.
•
Disassemble spline and check bearing for corrosion and
damage.
•
Make sure front wheel axle bolt is not too tight and is not
binding forks
Front wheel is not pulling
•
Make sure engagement switch is turned on and the en-
gagement spline is functioning properly.
•
Check clutch setting for proper torque using “wheel
check method”.
Drive system is pulling to one side
•
Perform “Sprag bearing test” as described in manual
•
Check sprag bearings in hub to make sure neither side is
slipping.
•
Make sure that drive shafts are free to spin smoothly.
Occasionally mud or other debris can hinder one drive-
shaft from spinning at the proper rate.
Clutch Basket has notches in it.
•
This is normal. As long as the notches don’t exceed
3/16”, Replacement is not needed.
Cannot disengage system
•
With bike in neutral rock it back and forth and use the
lever to disengage the system.
•
Engagement cable has too much slack in it. Use barrel
adjuster to take slack out of cable.
AWD Troubleshooting
Problem Problem Problem Problem Solution Solution Solution Solution