Christie Roadster HD14K-J, User Manual, Page: 28 / 182

2-14 J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
Section 2: Installation and Setup
1. Position the projectors.
• Place each projector to be stacked on a secure
table or cart.
• Place 1 projector on its side to access its adjust-
able feet, and stacking legs (Figure 2-17) .
• Orient the other projector in either upright or
inverted position as required (remember, each
projector in a stack must be in the same orienta-
tion).
2. Fully retract the 4 adjustable feet.
Fully retract each foot (4) as far as possible by
turning them clockwise.
• If upright, retract the feet on top projector.
• If inverted, retract the feet on bottom projector
3. Extend the 3 stacking legs.
Extend the stacking legs (3) by turning them so that at
least 1 inch of thread is visible on each. This clearance
accommodates the up-or-down movement for aligning
the images from the stacked projectors. Ensure that you
extend all 3 legs equally (see
Figure 2-18 ) so they are
level.
• If upright, extend legs on top projector (shown)
• If inverted, extend legs on bottom projector
IMPORTANT!
Extend the stacking legs equally by at least
1 inch.
Figure 2-17 Adjust the Feet
Figure 2-18 Extend 3 Stacking Legs
(UPRIGHT STACK SHOWN)